驱鸟装置基本的工作方式 The basic working mode of the exorcizer 启动智能综合驱鸟器开关，当检测到有鸟类靠近时，强光频闪、超声波、语音、工作状态指示灯开始工作。 Start the intelligent omni-drive switch, and when the bird is detected, the bright light, ultrasonic, voice and working status indicator will start to work. 此款驱鸟器也可以使用在变电站，仓库，机场等场所。（下图为变电站的安装图） It can also be used in substations, warehouses, airports and other places. (image below is installation diagram of substation) 注意事项 Matters needing attention （1）安装前检查驱鸟器各部分是否完好，打开电源开关试验是否开机工作，经检验完好，工作正常，则将开关关闭，即开关搬至（0）的位置。 (1) check QuDiao machine parts before installation, open the power switch test whether work boot, inspected and in good condition, work fine, will switch is closed, the switch is moved (0) position. （2）将每台驱鸟器的固定夹件和固定螺栓准备好。 (2) prepare the fixed and fixed bolts of each exorator. （3）将太阳能板朝上放置在铁塔的角钢横梁上。 (3) place the solar panels on the steel beams of the tower. （4）用螺栓将固定夹件与驱鸟器联接固定在铁塔的角钢上。 (4) connect the fixture with the bolt to the Angle steel of the tower. （5）安装后，将电源开关打开，此时指示灯亮，持续3秒左右进入工作状 (5) after installation, turn on the power switch, indicating that the light will be on for about 3 seconds 态。 State.